ISO 9001:2015 Certified
24 X 7
+91 99740 92362
Get A Quote

WR SVCC System

WR SVCC SYSTEM is a thermal spraying process that produces high density coatings of less than 1% porosity. The Results are very close to HVOF Process ar even better.The oxide levels is also less than 4%.

The Process :

In this process, the high electric arc energy from the two consumable wires heats gas inside a small vessel which is pressurized due to both ionization and the hot expanding gas, a jet stream exits a small port in front of which the wires are positioned and then melted, atomized, and propelled to the substrate. Controlling the arc gap is another essential part of the process. WR SVCC SYSTEM has mastered means to maintain an exact arc gap to allow nano scale particles to develop during atomization. Without this arc gap control the wires will actually interfere with the atomization process and cause a mix of large and small particles and therefore increase porosity.

Specifications :
  • Power Supply: ( N/S) Conventional 450 Amp. Incoming power; 3 phase multi Voltage at 60 Hz
  • Feeder with our 6 Roll Power Drive System: 55 Lbs.
  • 12.5′ Front End Leads with a Jet Force Head
  • Power/ Control Lead
  • Wire Capabilities: All Conductive Wires; ⅛ ” (3.2mm), 3/32;” (2.3mm), 2mm or 1/16;” (1.6mm)
  • Air Requirements: 80-100 PSI at 70 CFM. Air inlet no less than ½ ” dia.
Available Options :
  • Inverter Style Power Supply
  • Pendant Control on/off Switch
  • Change over kits for different wire sizes
  • Tool Post Mount
  • Angle Spray Nozzle
  • Wire Dispenser for Payoff wire drum