ISO 9001:2015 Certified
24 X 7
+91 99740 92362
Get A Quote

Ultra Primer

ULTRA PRIMER is a two-component polyamide cured high solid epoxy coating, especially designed to improve the anti-corrosive properties of coating and to extend the life of protective coating. It can be used as intermediate as well as to suit tropical environments.

Characteristics :

ULTRA PRIMER having a lamellar micaceous iron oxide as the main corrosion inhibitive pigment. These lamellar flakes of micaceous iron oxide align parallel to the substrate surface, producing a shield or barrier of overlapping plates. This alignment enhances protection by providing –

  • Barrier protection.
  • Ultraviolet (UV) light absorption.
  • Film Strength.
  • Increased inter coat adhesion.
  • Reduced erosion rates.
  • Extended life of protective coating.
  • Increased mechanical & chemical properties.
Application Details :

Stir the base thoroughly and mix with hardener in recommended proportions to a homogeneous mixture. Allow the mixture to mature for approx. 30 minutes and stir again before and during application.

BRUSH : Apply without thinning.

AIRLESS SPRAY : Apply without thinning. Maximum of 5% thinning with thinner ET 1 is recommended if it’s absolutely essential.  Use standard equipment having pump ratio of 40:1, Tip size 0.48 – 0.53 mm, and Tip pressure 140 – 165 kg/cm²