ISO 9001:2015 Certified
24 X 7
+91 99740 92362
Get A Quote

Ultra Therm-HT

UltraTherm-HT is a design of several specially formulated resins and additives to provide a base that is flexible enough to withstand severe climate changes, as well as severe heat peaks without loss of adhesion. A select group of ceramic materials are used in the formula to achieve a stoppage of  heat, fire, smoke and gases from passing through the coating. This coating is designed to stay intact with constant adhesion above 2000º F. This is not an intumescent coating but instead a pliable film that reacts to flame. The face of the coating but will glaze during a fire to form a complete protection shield against flame, smoke, gases and heat.

How is it applied ?

Surfaces must be clean and dry before. Loose or flaking old paints or corrosion must be removed from surface, before applying. High-pressure water blasting is as effective as light sand blasting in removing loose or flaking surfaces. Grease, oil, waxy substances, dirt, etc. must be cleaned from surfaces. Old paints can remain if bonded solidify to surfaces. It can bond to metal, masonry, wood and other porous surface substrates. It is best applied by airless or spray pot due to the consistency of the coating. If necessary, the use of a 3/4 inch nap roller or brush is possible and may take multiple coats to apply required mils (allow one day dry-time between coats). If spray equipment is used, carbon steel tips (size: 0.045 or 1.4mm) are recommended and a machine pumping at 3 gallons/ minute with a minimum of 3000 psi (8-20 horse motor).

For application to hot pipes or if needed for spraying, dilute with a slurry of 30% UltraTherm, 70% UltraTherm – HT. Apply thick layers of 100 mils per coat on single coat. Allow to dry overnight before re coating.

This is a water-based coating. Never apply if raining or chance of rain on the day of application.

Important : All filters must be removed to prevent sifting of ceramic particles.