ULTRASLIDE SL

In the core sector industries the problems like caking, freezing, ratholing and bridging in the flow distribution of bulkmaterials are still the prime and never ending problems with unsatisfactory and non-durable solutions.We are introducing ULTRASLIDE-SL as the unique, satisfactory and highly durable solution to end the non-ending flowdistribution problems.ULTRASLIDE-SL,a u nique low friction coating, can be deposited on any substrate and is exceptionallywear-resistant.

Designed to alleviate the traditional problems of flow distribution, such as bridging,
ratholing, caking and freezing, in bulk solids handling systems.It is suitable fora wide range of materials and particle sizes, in wet or dry conditions, such as coal, sand, limestone, iron ore and other minerals.Typical applications include bunkers, hoppers, silos, as well as chutes, troughs, conveyors,wagon s and trunks,

Features

Prevents bridging and ratholing.
Outstanding abrasion resistance, High build.
Performs in dry service conditions up to 160 C.
Chemical resistant.
Self polishing surface.
Alleviates flow problems& ensures continuity of bulk flow.
Providesa continuous joint free membrane which is easy to maintain

Technical Data

Appearance	Red orGrey
Appearance when dry	Glossy
Storage Temperature C	Minimum 0 C maximum 35 C
Shelf Life (months)	24
Volume Solids	89 + 2%
VOC (g/l)	97
Dry firm thickness(micron)	Typical 500 minimum 350 maximum 500 Wet film thickness quoted are theoretical for one airless spray coat.
Theoretical Coverage	1.8 square metre/ litre
Pot Life (at 20 C)	1 hour

Surface Preparation

Steel: Applied over Ultraslide Steel Primer
Concrete : Applied over Ultraslide Concrete Primer. The surface must be dry and free of dust, salt, grease and other contaminants immediately before coating.

Mixing

Stir the base component thoroughly, then add the activator and continue mixing until the product is uniform throughout.A powerful mixer should be used. No indication period is necessary after mixing.

Overcoating

Can be overcoated with itself if necessary. Surface must be abraded if overcoating after maximum overcoating time has elapsed.

Drying Characteristics

Temperature	10 0C	20 0C	300C
Touch Dry (hrs)	10	6	4
Hard Dry (hrs)	24	16	12
Fully Cure (hrs)	168	120	96
Overcoating (min) (hrs)	12	8	6
Overcoating (max) (hrs)	72	48	36

Applying Procedure

Airless Spray: Tip size 26-30 thou’ (0.66- 0.76 mm). Usea pump minimum ratio 45:1 (Graco “King or equivalent) capable of producinga minimum pressure at the tip of 3600 psi (250 kg/cm ). Allow for tip wear due to the nature of the product.

Use 1/2″ dia., spray lines with 3/8″ dia., whip end keep runs as short as possible. Remove in line filters, use large mesh sieve at pump intake. Brush small areas only.

Packaging

4 and 20 litre in two part units